WDT Watchdog Timer Interfaces For The Linux Operating System¶

Last Reviewed: 10/05/2007

ICS WDT501-P

ICS WDT501-P (no fan tachometer)

ICS WDT500-P

All the interfaces provide /dev/watchdog, which when open must be written to within a timeout or the machine will reboot. Each write delays the reboot time another timeout. In the case of the software watchdog the ability to reboot will depend on the state of the machines and interrupts. The hardware boards physically pull the machine down off their own onboard timers and will reboot from almost anything.

A second temperature monitoring interface is available on the WDT501P cards. This provides /dev/temperature. This is the machine internal temperature in degrees Fahrenheit. Each read returns a single byte giving the temperature.

The third interface logs kernel messages on additional alert events.

The ICS ISA-bus wdt card cannot be safely probed for. Instead you need to pass IO address and IRQ boot parameters. E.g.:

wdt.io=0x240 wdt.irq=11

Other “wdt” driver parameters are:

heartbeat

Watchdog heartbeat in seconds (default 60)

nowayout

Watchdog cannot be stopped once started (kernel build parameter)

tachometer

WDT501-P Fan Tachometer support (0=disable, default=0)

type

WDT501-P Card type (500 or 501, default=500)

Features¶


Reboot Timer	X	X
External Reboot	X	X
I/O Port Monitor	o	o
Temperature	X	o
Fan Speed	X	o
Power Under	X	o
Power Over	X	o
Overheat	X	o

The external event interfaces on the WDT boards are not currently supported. Minor numbers are however allocated for it.

Example Watchdog Driver:

see samples/watchdog/watchdog-simple.c